Round Bust resin display plinths, cast in black resin with a 40 degree slant. Plinths are supplied pre-drilled with a 40mm long metal rod in either 3.2mm or 2.4mm diameter. Also available without a rod and with no drilled hole, although a shallow 3mm pilot hole will remain (this is a cast in drilling guild)
After casting each plinth is machined sanded to ensure the bottom is parallel and true. I inspect each plinth and fill and sand any imperfections, although sometimes I miss things.
Sizes I am currently producing are 45mm, 40mm and 35mm in diameter. The finished height is approximately 65mm to the highest point, this height can vary plinth to plinth but I always aim to match finished heights across multiple plinths in an order.
A scaled printout of each size can be found HERE
Now offering Magnet or Screw inserts for your plinths
PRODUCTION - PLEASE READ!
Due to the amount of resin required to produce these plinths they will be cast to order. This can mean a lead time of up to a week prior to shipping. I would always recommend ordering ahead of time if you require them for a competition. I will always strive to cast items immediately and aim to get orders out the next day.
Your plinths may arrive in a sanded and prepared state, each and every plinth I cast is meticulously inspected for imperfections these are then filled and sanded out.
PREPARATION
Prior to use it is recommended to clean each piece is warm soapy water to remove residue release agent. Persistent release and silicone residue will remove with spirit based fluid and an old tooth brush. Wash in water after using spirit based cleaners. If any small bubbles are present they can be filled with superglue applied from a pin tip and sanded back. Always wet sand resin using fine grit wet and dry, sanding from course to fine paper to remove surface marks (240, 320, 400, 600 grit for example). I would always recommend spraying your plinth in a flat coat of black to even out the colour.
DISCLAIMERS
This web store is and its contents are in no way endorsed, or affiliated with Games Workshop Limited. Imperial Knight Dominus Valiant, Imperial Knight Dominus Castellan, Imperial Knight Titan, Imperial Knight Warden, Imperial Knight Paladin, Imperial Knight Errant, Imperial Knight Crusader, Imperial Knight Gallant, Armiger Warglaive, Titanicus and the Warhammer 40,000 name are either ® or ™, and/or © Games Workshop Limited, variably registered around the world. Photographs of existing miniature kits are used only to show scale and compatibility with the accessories found on this page. Used without permission. No challenge to their status intended. All Rights Reserved to their respective owners.
Choking hazard. Not meant for children 16 years or younger.
Every effort is taken to prevent bubbles, although time to time some small bubbles will remain. All measurements are approximate due to resin shrinkage as environmental conditions change during the casting process. Heights are Approximate and can vary each way by a few millimetres. Supplied unpainted