Dreadnought Contemptor resin elbow connector is a replacement component for easy magnetization and weapon loadout changes of arms. The joint is created solid with a centre mark to make for easy magnet drilling, 2mm thick magnets are ideal. Allowing you to make use of all the weapons from your sprues without wastage, after all wasted plastic is bad for the environment. One elbow connector supplied.
COMPATIBILITY
This component is compatible with new contemptor dreadnought plastic weapons.
PREPARATION
Prior to use it is recommended to clean each piece is warm soapy water to remove residue release agent. Persistent release and silicone residue will remove with spirit based fluid and an old tooth brush. Wash in water after using spirit based cleaners. Glues with superglue
DISCLAIMERS
This web store is and its contents are in no way endorsed, or affiliated with Games Workshop Limited. Imperial Knight Dominus Valiant, Imperial Knight Dominus Castellan, Imperial Knight Titan, Imperial Knight Warden, Imperial Knight Paladin, Imperial Knight Errant, Imperial Knight Crusader, Imperial Knight Gallant, Armiger Warglaive, Titanicus, and the Warhammer 40,000 name are either ® or ™, and/or © Games Workshop Limited, variably registered around the world. Photographs of existing miniature kits are used only to show scale and compatibility with the accessories found on this page. Used without permission. No challenge to their status intended. All Rights Reserved to their respective owners.
Choking hazard. Not meant for children 16 years or younger.
Every effort is taken to prevent bubbles, although time to time some small bubbles will remain. Supplied unassembled, unpainted and will require split lines to be removed.