This entirely new range of backdrop plinths is our most comprehensive yet, with six to choose from. As popular as our existing backdrops are these have a completely flat platform, allowing for ease of modelling right up to the backboard. Also extending the heights of the backboards, allowing you to cut them down to suit.
With six in the range all needs should be covered. The two smallest are 40 and 45mm wide and measure 40mm deep with a 95mm backboard. The smaller of the mediums is 50mm wide, 45mm deep with a 100mm board. Then we have a 60mm wide, 55mm deep and 120mm backboard
Our Largest are 70mm wide, 65mm with and 140mm board, the the largest of the two 80mm wide, 75mm deep with a 160mm backboard
Every plinth is cast in a durable black resin and has been machine sanded on the rear face to ensure a true backdrop. I inspect each plinth and fill and sand any imperfections, although sometimes I miss things.
Find a helpful scaled printout of each profile HERE
Now offering Magnet or Screw inserts for your plinths
PRODUCTION - PLEASE READ!
Due to the amount of resin required to produce these plinths they will be cast to order. This can mean a lead time of up to a week prior to shipping. I would always recommend ordering ahead of time if you require them for a competition. I will always strive to cast items immediately and aim to get orders out the next day.
Your plinths may arrive in a sanded and prepared state, each and every plinth I cast is meticulously inspected for imperfections these are then filled and sanded out.
PREPARATION
Prior to use it is recommended to clean each piece is warm soapy water to remove residue release agent. Persistent release and silicone residue will remove with spirit based fluid and an old tooth brush. Wash in water after using spirit based cleaners. If any small bubbles are present they can be filled with superglue applied from a pin tip and sanded back. Always wet sand resin using fine grit wet and dry, sanding from course to fine paper to remove surface marks (240, 320, 400, 600 grit for example). I would always recommend spraying your plinth in a flat coat of black to even out the colour.
DISCLAIMERS
This web store is and its contents are in no way endorsed, or affiliated with Games Workshop Limited. Imperial Knight Dominus Valiant, Imperial Knight Dominus Castellan, Imperial Knight Titan, Imperial Knight Warden, Imperial Knight Paladin, Imperial Knight Errant, Imperial Knight Crusader, Imperial Knight Gallant, Armiger Warglaive, Titanicus and the Warhammer 40,000 name are either ® or ™, and/or © Games Workshop Limited, variably registered around the world. Photographs of existing miniature kits are used only to show scale and compatibility with the accessories found on this page. Used without permission. No challenge to their status intended. All Rights Reserved to their respective owners.
Choking hazard. Not meant for children 16 years or younger.
Every effort is taken to prevent bubbles, although time to time some small bubbles will remain. All measurements are approximate due to resin shrinkage as environmental conditions change during the casting process. Heights are Approximate and can vary each way by a few millimetres. Supplied unpainted